 |
| X-Y slide bushing |
The bushing is made from two 4" pieces of 1" PVC pipe then I filed a flat spot into each one in the middle to allow for good adhesion with the epoxy. The nails in the scrap wood in the pictures below are the jig I made to make sure the two pipe sections were 90 degrees from each other.
 |
| threaded rod with a slide rail attached |
 |
| X-Y assembly |
Here is the X-Y assembly which will have a frame built around it as well as having the motors attached to an end of each section of threaded rod.
-Michael Spaulding
No comments:
Post a Comment